攪拌車體檢標準流程有哪些？
攪拌車機油檢查
Oil inspection of mixer truck
只要隔幾天把油表尺拔出，擦干凈、再放進去、再拔出來，看看機油的液面高低是否在上限與下限之間。如果在日常的檢查中發現機油內有雜質或汽油味，以及排煙呈現淡藍色，就表示引擎出了問題，機件可能異常磨損，需要趕快檢修哦
Just pull out the oil gauge every few days, wipe it clean, put it in and pull it out again to see if the oil level is between the upper and lower limits. If impurities or gasoline smell are found in the engine oil during daily inspection, and the smoke exhaust is light blue, it indicates that there is a problem with the engine, the parts may be abnormally worn, and it needs to be repaired as soon as possible
攪拌車汽油檢查
Gasoline inspection of mixer truck
要勤于查看油表是否到底。千萬不要讓油表到底了再去加油，新車多都采電動汽油泵棒以及油量電子感應器，要注意讓它浸泡在汽油里散熱，此外油量太低，也可能影響排氣系統的氧傳感器器，這些零件都不便宜，所以勿超過底線才去加油。
Be diligent in checking whether the oil gauge is in the end. Never let the fuel gauge go to the end before refueling. Most new cars use electric gasoline pump rods and electronic fuel volume sensors. Pay attention to let it soak in gasoline to dissipate heat. In addition, too low fuel volume may also affect the oxygen sensor of the exhaust system. These parts are not cheap, so don't refuel beyond the bottom line.
攪拌車變速箱油檢查
Inspection for gearbox oil of mixer truck
檢查變速箱油，為了測量準確，應該將車排入空檔P，以怠速運轉，并將車停在平坦的地方，且油液必運轉至80℃~93℃的工作溫度。油液過多或過少，都可能損害變速箱，油液過多可能會造成機件運轉阻力過大，或者使得變速箱油起泡變質而致機件不正常磨損。
Check the transmission oil. In order to measure accurately, drain the vehicle into neutral P, run at idle speed, park the vehicle in a flat place, and the oil must run to the working temperature of 80 ℃ ~ 93 ℃. Too much or too little oil may damage the transmission. Too much oil may cause excessive running resistance of parts, or make the transmission oil bubble and deteriorate, resulting in abnormal wear of parts.
攪拌車剎車油如何檢查
How to check the brake oil of mixer truck
只要打開引擎蓋，看看剎車油壺的液面高低，要不低于下限。在未檢查剎車油液面高度時，不可添加剎車油，以免添加過量，而使剎車油噴灑至高溫引擎，導致機件腐蝕甚至起火燃燒。如果剎車油中起了氣泡，或油變臟了，就表示剎車油已經變質了，請盡快更換，以免剎車油沸點降低產生氣泡，造成剎車效果變差，容易發生危險。
Just open the engine hood and check the level of the brake oil pot. It should not be lower than the lower limit. When the brake oil level is not checked, do not add brake oil to avoid excessive addition, which will spray the brake oil to the high-temperature engine, resulting in parts corrosion and even fire. If there are bubbles in the brake oil or the oil becomes dirty, it means that the brake oil has deteriorated. Please replace it as soon as possible to avoid bubbles caused by the reduction of the boiling point of the brake oil, resulting in poor braking effect and danger.
