如何保持全自動攪拌車的良好性能？
如何保持全自動攪拌車的良好性能？
How to maintain the good performance of automatic mixer?
1.日常操作后，駕駛員應將清水倒入混合罐中，以高速（14-18 rpm）旋轉5-10分鐘，排干水并確保滾筒清潔。用高壓水清潔混合桶的所有零件時，必須注意不要使用諸如外觀或操縱桿之類的零件。壓力水噴嘴與車身涂料外部之間的距離應至少為40厘米。
1. After daily operation, the driver should pour clean water into the mixing tank, rotate at high speed (14-18 RPM) for 5-10 minutes, drain the water and ensure that the drum is clean. When cleaning all parts of the mixing drum with high-pressure water, care must be taken not to use parts such as appearance or control lever. The distance between the pressure water nozzle and the exterior of the body paint shall be at least 40 cm.
2.在施工現場卸貨后，請使用配有自動混凝土攪拌機的料斗，料斗，卸料斜槽等清潔污泥和粘附在主體上的混凝土。在返回攪拌站的途中，應將150-200升水倒入攪拌罐中，以除去攪拌罐壁和葉片上的任何混凝土殘留物。液壓系統的壓力必須符合使用說明書，并且不能隨意調節。液壓油的質量和數量必須符合原始要求。
2. After unloading at the construction site, please use the hopper, hopper and discharge chute equipped with automatic concrete mixer to clean the sludge and the concrete adhered to the main body. On the way back to the mixing plant, 150-200 liters of water should be poured into the mixing tank to remove any concrete residue on the tank walls and blades. The pressure of the hydraulic system must conform to the instruction manual and cannot be adjusted at will. The quality and quantity of hydraulic oil must meet the original requirements.
3.在冬季工作期間，您需要執行以下操作：開始之前請檢查冰塊。下班后，仔細沖洗混合水箱和供水系統中的剩余水，關閉泵，將控制手柄置于“停止”位置。
3. During the winter work, you need to do the following: please check the ice before you start. After work, carefully flush the remaining water in the mixing water tank and water supply system, turn off the pump and put the control handle in the "stop" position.
4.了解全自動攪拌車的結構，工作原理和操作方法可以保證設備的更好性能！
4. Understanding the structure, working principle and operation method of automatic mixer can ensure better performance of the equipment!
以上就是關于"如何保持全自動攪拌車的良好性能"的介紹，希望對大家有所幫助。
The above is about "how to maintain the good performance of automatic mixer" introduction, I hope to help you.
